Daycare & Childcare Facility Roofing in Orlando, FL

The EPA Renovation, Repair, and Painting Rule requires that contractors performing renovation work that disturbs lead-based paint in facilities that serve children under six hold EPA RRP certification and follow specific work practice standards — contained work areas, no dry sanding or open-air demolition, HEPA vacuum cleanup, and post-work clearance verification. If your facility was built before 1978, assume lead-based paint is present until a certified inspector tests and clears it. We are RRP-certified and include lead assessment as a standard pre-construction step on pre-1978 facilities.

We conduct a pre-tearoff thermal scan of the existing roof system during the appropriate ambient conditions — the evening cool-down period — and take core samples at locations showing thermal anomalies. Wet insulation retains heat differently than dry insulation and shows clearly in the thermal image. Core sample results confirm moisture content and document deck condition. If wet insulation is found, it's removed and replaced as part of the re-roofing scope — not covered over with new insulation, which only traps moisture.

For work near or within childcare facilities, we select products with the lowest available VOC content — water-based adhesives where the application allows, VOC-compliant primers for the FL air quality district, and low-odor membrane systems. We don't apply solvent-based adhesives or primers on work days when the facility is occupied in any adjacent section. Every product used on a childcare roofing project in Orlando has an SDS sheet on file at the job site and a copy submitted to the facility director before the product is used.

Most childcare facilities in Orlando are low-slope commercial buildings — flat or low-pitch roofs with standard deck construction. A mechanically attached or fully adhered 60-mil TPO system over polyiso insulation is the appropriate specification for most childcare buildings: low-maintenance, compatible with the typical wood-frame or light commercial steel deck construction, and compatible with standard penetration types. For facilities with existing BUR or modified bitumen systems that are in recoverable condition, a coating system may extend service life at lower cost — but only after a moisture survey confirms the existing insulation is dry.

HVAC penetration relocation on a childcare building — moving a supply air intake away from an exhaust termination, raising a return air intake above the new insulation thickness — is coordinated with the facility's HVAC maintenance contractor before roofing work begins. We confirm that the proposed penetration configuration meets the manufacturer's clearance specifications and local code requirements for ventilation intakes at occupancies serving children. Penetration relocation is documented in the project record and included in the facility's equipment maintenance file.